Hytera HP782 - Receiving an All Call; Ending an All Call; Broadcast Call (Trunking Only); Initiating a Broadcast Call

23
6.3.2 Receiving an All Call
You can answer an all call without any operation.
6.3.3 Ending an All Call
Conventional Mode
An all call ends when the calling party releases the PTT key.
Trunking Mode
In trunking mode, an all call ends in any of the following cases:
 The calling party releases the PTT key.
 The calling party hangs up.
 The call duration exceeds the preset time.
 The BS signal is lost.
 With the Clear Down feature enabled, the calling party changes the contact.
6.4 Broadcast Call (Trunking Only)
A broadcast call is a special group call, during which only the calling party can transmit voice.
The Broadcast Call feature is preprogrammed by your dealer.
6.4.1 Initiating a Broadcast Call
Through Contact List
 Subgroup Contact List
a. Press the Back/Subgroup key or the preprogrammed Current Subgroup Contact key.
b. Select the subgroup and group contact.
c. Set the call type to Broadcast Call.
d. Press the P1/Answer key or the PTT key.
 Favorite Contact List
a. Press the preprogrammed Favorite Contact List key, or go to Menu > Contact > Favorite.
b. Select the group contact.