Hytera HR106X - Compliance with RF Exposure Standards; FCC Statement; FCC Regulations; Operational Instructions and Training Guidelines

3
Basic Operations
Turning On or Off the Repeater
●
If the repeater is connected to a DC power supply, press
the power switch on the DC power supply to turn on or
off the repeater.
After turn-on, if the power supply indicator turns red,
the repeater goes into locked status. You must switch off
the DC power supply for four seconds, and then switch
on the power supply again.
●
If the repeater is connected to an AC power supply, press
the AC Power Switch in the rear panel to turn on or off
the repeater.
After turn-on, the power supply indicator turns yellow.
Changing the Channel
Press the Volume/Channel + or Volume/Channel – key to
change the channel.
The current channel number appears on the display of the
repeater.
Adjusting the Volume
1. Long press the Volume/Channel + key for ve seconds
to switch the repeater from channel mode to volume
mode.
2. Press the Volume/Channel + or Volume/Channel – key
to increase or decrease the volume.
If you do not have any operation for greater than five
seconds or if you long press the Volume/Channel + key
again within ve seconds, the repeater switches to channel
mode.
Checking the Status
Repeater
Indicator Description Repeater Status
Digital
Mode
Blue
The repeater is operating in
digital mode.
Analog
Mode
Yel low
The repeater is operating in
analog mode.
Alarm Red
The repeater is not working
properly, and the display
shows the alarm code.
Timeslot A
TX
Red
●
Analog mode: The
repeater is transmitting.
●
Digital mode: The
repeater is transmitting
on timeslot A.
Timeslot A
RX
Green
●
Analog mode: The
repeater is receiving.
●
Digital mode: The
repeater is receiving on
timeslot A.
Timeslot B
TX
Red
Digital mode: The repeater is
transmitting on timeslot B.
Timeslot B
RX
Green
Digital mode: The repeater is
receiving on timeslot B.
Network Interface
Indicator Description Repeater Status
Ethernet
Interface
LED 1
Flashing
The network interface
card is transmitting
data.
LED 2
Glowing
The data transmission
rate is 1000 Mbps/100
Mbps.
Off
The data transmission
rate is 10 Mbps.
Power Supply
Indicator Description Repeater Status
Power Supply
(Visible through
the Air Inlet for
Power Supply)
Yel low
The repeater is supplied
by an AC power.
Blue
The repeater is supplied
by a DC power.
Red
The repeater cannot be
turned on.
For details on more features and operations, please visit our
website at: http://www.hytera.com, or scan the QR code to
download the User Manual.