25
Channel Steering
This feature must be realized through further development. After
successfully developed, you should request your dealer to enable
it via programming software. You can switch channels accurately
and quickly with this feature.
Note: If this feature is enabled, you cannot switch
channels via front panel operation.
Radio Registration Service
If enabled via the programming software, your radio will
automatically register in the system within a certain period after
power-on. Then it can acquire online information of other radios
via accessing specic servers within the valid registration period.
GPS Revert
If enabled via the programming software, your registered radio
will transfer its positioning information to the system when the
system requires such information.
Lone Worker
This feature is ideal for persons who work lonely. If you encounter
an incident and cannot operate your radio within the preset time
period, your radio will alarm automatically to summon help from
your companion.
Operation:
1. To enable the feature,
Go to “Main Menu -> Settings -> Radio Set-> Lone Worker”
and select “Enable”; or Press the programmed Lone Worker
key (a high-pitched tone sounds); or Turn on the radio if the
feature is enabled via the programming software.
2. If you cannot operate your radio within a preset response
period, your radio will give alerts before this period expires
(dependent on the settings by your dealer). At this time, you
can terminate such alerts by rotating a knob or pressing a key.
When the response period expires, your radio will trigger the
current emergency system automatically.
3. To disable the feature,
Go to “Main Menu -> Settings -> Radio Set-> Lone Worker”
and select “Disable”; or Press the programmed Lone Worker
key (a low-pitched tone sounds).
Note: If the Lone Worker feature is not disabled
before your radio is powered off, it will
remain enabled when powered on again.
Functions and Operations
To Next Page
Loading...
Need help?
General
