Hytera PD785 Quick Start Guide

English
66
Note: You cannot respond to an All Call.
■
Calls on Analog Channels
To transmit on an analog channel, hold down the PTT and speak
into the microphone. To receive, release the PTT key.
■
Phone
If the repeater is connected with a PSTN gateway (such as
Zetron M30), the radio can communicate with the phone via it.
Transmitting a phone call:
1. Access the phone system.

Live Dial
Hold down the PTT key, and enter the access code via the
keypad. Then release the PTT key. The radio beeps and
displays the dialing information. When the phone system is
accessed successfully, the radio goes to the DTMF keypad
mode.

Buffer Dial
1) Enter the DTMF keypad mode. The following methods are
available to enter this mode.

Go to “Menu -> Phone –> Manual Dial” to enter the
DTMF keypad mode.

Press the programmed DTMF Keypad key.

Go to “Menu -> Phone -> DTMF Keypad”, and then
select “Enable". The number entered via the keypad in
the home screen is the DTMF code.
2) Access the phone system: Enter the access code via the
keypad and then press the PTT key. The radio beeps and
displays the dialing information. When the phone system is
accessed successfully, the radio goes to the DTMF keypad
mode again.
2. Make the phone call.

Live Dial: Hold down the PTT key and enter the phone
number via the keypad. Release the PTT key after the
complete number is entered.

Buffer Dial: Enter the phone number via the keypad and
then hold down the PTT key.

Select “Back”. Then go to “Menu -> Phone ->Phone List” to
select a desired contact, and press the PTT key.
3. After the call is established, you can hold down the PTT key
to talk, and release it to listen.
To end the call, you can send the de-access code (the input
method is the same as that for the access code) to exit the
phone system.
If the phone is hung up, the call will be ended and the phone
system will be exited too.
Receiving a phone call:
When the radio receives a phone call, the icon or will
appear.
You may hold down the
PTT
key within the preset time period
to call back. If you do not respond to it, your radio will provide
appropriate indications. The indication information is the same as
that for the Private Call.

Hytera PD785 Specifications

General

Channel Capacity	1024
Zone Capacity	64
Operating Voltage	7.4V
Weight	335 g
IP Rating	IP67
Operating Temperature	-30°C to +60°C
Frequency Range	VHF: 136-174 MHz, UHF: 400-470 MHz
RF Power Output	VHF: 5 W, UHF: 4 W
Channel Spacing	12.5 kHz/25 kHz
Digital Protocol	DMR
Bluetooth	Yes
GPS	Yes
Digital/Analog	Yes
Dimensions	124 X 55 X 37mm
Display	1.8 inch, 65536 colors