Hytera PD785 - Emergency Mode Exiting; Exiting Emergency Mode

SPECIALIST
RADIO
30
Alarm” is enabled via the programming software, an alarm tone will sound.)
Two methods are available for you to exit the Emergency mode:
1. Once the Alarm Cycles expire, the radio will exit the Emergency mode automatically.
2. Long press the programmed Emergency key.
 Alarm with Call (None & HDC1200)
Operation:
1. Press the programmed Emergency key to send alarm information. The radio displays the icon
and text information “Sending Alarm”, with red LED glowing. (None: If “Local Emergency Alarm” is
enabled via the programming software, an alarm tone will sound.)
2. When the icon
appears, you can speak into the microphone to make an emergency call.
3. When the icon
appears, you can receive. And when a call is received, the icon
appears.
4. If the preset Voice Cycles expire, you can hold down the PTT key to make the emergency call again
(the radio displays the icon
, with red LED glowing). After the emergency call is transmitted,
release the PTT key to receive (the radio displays the icon
, with LED flashing orange rapidly).
And when a call is received, the icon
appears. (HDC1200 only)
Two methods are available for you to exit the Emergency mode:
1. After the preset Alarm Cycles and Voice Cycles expire, the radio will exit the Emergency mode
automatically. (None)
2. Long press the programmed Emergency key.
 Call Only (HDC1200)
Operation:
1. Press the programmed Emergency key to go to the Revert Channel, and the radio displays the icon
.
2. If the feature “Alarm with Call to Follow” is enabled, you can speak into the microphone to make an
emergency call when the radio displays the icon
.