35
Alert: The radio will sound default alert.
LED: The LED glows green.
LCD: If your dealer enables the feature “Display Decode ID”, the radio will display the
appropriate call icon (Private Call:
; Group Call: ; All Call: ) and
alias of the transmitting party (ID of the transmitting party will be displayed if it is not in
the contact list). If your dealer does not enable the feature “Display Decode ID”, the
radio will display the appropriate call icon only.
Troubleshooting
Phenomena Analysis Solution
The radio can not
be powered on.
The battery may be
improperly installed.
Remove the battery and
attach it again.
The battery may run out.
Recharge or replace the
battery.
The battery may suffer from
poor contact caused by dirtied
or damaged battery contacts.
Clean the battery contacts. If
the problem can not be solved,
contact your dealer or
authorized service center for
inspection and repair.
During receiving
signals, the voice is
weak,
discontinuous or
totally inactive.
The battery strength may be
too low.
Recharge or replace the
battery.
The volume may be set to a
low level.
Increase the volume.
The antenna may get loose or
may be improperly installed.
Power off the radio, and
re-install the antenna.
The speaker may be blocked
or damaged.
Clean surface of the speaker.
If the problem can not be
solved, contact your dealer or
To Next Page
Loading...
