To Next PageTo Next PageWhat to do if I hear loud popping or grinding noise from my HYTROL Industrial Equipment?
If you hear a loud popping or grinding noise coming from your HYTROL Industrial Equipment, it could be due to a defective bearing. Replace the bearing. Another cause could be loose set screws in the bearing, so tighten the set screw. Also, check for a loose drive chain and tighten the chain if necessary.
What to do if belt is moving, but tread rollers are not turning on my HYTROL Industrial Equipment?
If the belt is moving but the tread rollers are not turning on your HYTROL Industrial Equipment, it could be due to not enough pressure against the belt from the pressure rollers. Tighten the spring tension on pressure rollers in the area of stalled rollers. Another cause could be a bolt in the suspension angle binding, not allowing adjustment of pressure rollers, so loosen the bolt and adjust spring tension as required and check for burrs or foreign material behind angles. Also, missing or broken springs or adjustment nuts can cause this issue, so replace and re-adjust them.
General| Brand | HYTROL |
|---|---|
| Model | 190-ACC |
| Category | Accessories |
| Language | English |
