Stop the engine, pull out the dipstick and check the oil level.
The oil surface line on the dipstick should be between H and L.
If below L, remove the filler cap and add engine oil through the
oil level.
If the cooling water in the radiator sub-tank is not within normal
range when cool, add water to the MAX line.
Always check the coolant level in the radiator sub-tank
prior to beginning of daily operation of
the machine.
5-4
CHECK BRAKE FLUID
3)
CHECK COOLANT LEVEL
4)
Remove reservoir cap, and check level.
If necessary, add brake fluid.
(1)
(1)
ö
35DFOM110
L255OM61
D35AOM112K
In antifreeze is being used, pay careful attention to the ratio of antifreeze and water when
adding co
olant.
If the sub-tank is completely empty, first add water directly to the radiator. Then add water to
the sub-tank.
Always allow the radiator to cool down before adding water.
At the operating temperatur
e, the engine cooling water is at high temperature and pressure,
so it is dangerous to try to open the
radiator cap. Wait until the radiator is cool enough to be
touched by hand before opening the radiat
or cap. Loosen the radiator cap slowly to release
the pressure, then loosen the cap.
After filling the
coolant into the radiator, check for leakage for the radiator, radiator hoses and
other parts of the
cooling system and also for traces of water leakage under the engine.
ö
Change the oil if it is marked dirty or discolored.
Oil level is to be checked with the truck placed a
t flat level and at least 3 minutes after the
engine stopped.
Do not touch hot components or allow hot oil to contact your skin.
ö
Dry type
Type
Brake fluid
DOT III
Wet type
Azola ZS10 or hyd oil SAE 10W
To Next Page
Loading...
Need help?
General
