1
FEATURES OF YOUR HYUNDAI
30
B200A01S-GAT
Adjusting Your Seat Belt
You should place the belt as low as
possible on your hips, not on your
waist. If the belt is located too high on
your body, you could slide under it in
case of accident or a sudden stop. This
could result of death, serious injury or
property damage. Both arms should not
be under or over the belt. Rather, one
should be over and the other under, as
shown in the illustration.
Never wear the seat belt under the arm
nearest the door.
B200A01NF
B210A01A-AAT
To Release the Seat Belt
The seat belt is released by pressing
the release button in the locking buckle.
When it is released, the belt should
automatically draw back into the retrac-
tor.
If this does not happen, check the belt
to be sure it is not twisted, then try
again.
B210A01NF
B220A01MC-AAT
SEAT BELTS (2-Point Static
Type) (Rear Seat Center)
(If Installed)
To Fasten Your Seat Belt
To fasten a 2-point static type belt,
insert the metal tab into the locking
buckle. There will be an audible "click"
when the tab locks into the buckle.
Check to make sure the belt is properly
locked and that the belt is not twisted.
B220A01MC
To Next Page
Loading...
Need help?
General
