What to do if there are vibrations in all movements when the oil is warm in HYVA HA10 Construction Equipment?
If you experience vibrations in all movements of your HYVA Construction Equipment when the oil is warm, it could be due to insufficient oil in the tank. Try adding hydraulic oil. It may also be caused by air inside the hydraulic circuit. In this case, operate the controls to fully extend and fully retract the cylinders several times.
Why is there oil leakage, load lowering, and power loss in my HYVA HA10 Construction Equipment?
If you notice oil leakage from the cylinders, the load lowers with the stationary pump, or there's a loss of power in your HYVA Construction Equipment, it's likely due to worn cylinder seals. It is suggested to go to an authorized workshop.
How to fix squeaking on articulation points of HYVA HA10?
If you hear squeaking on articulation points or the slewing unit bushing of your HYVA Construction Equipment, it's likely due to a lack of lubrication. Grease the articulation points or bushings to resolve this.
What to do if HYVA HA10 cylinders jerk during initial maneuvers?
If you experience vibrations in the crane cylinders or jerking in the boom extension cylinders during initial maneuvers of your HYVA Construction Equipment, the hydraulic oil temperature might be too low. Perform maneuvers without a load for several minutes to warm up the oil.
Why does the stabilizer leg close during crane work on my HYVA HA10 Construction Equipment?
If the stabilizer leg closes during crane work with your HYVA Construction Equipment, it could be due to a worn block valve on the stabilizer leg, resulting in no seal, or internal seals wear. It is suggested to go to an authorized workshop.
What causes the load limiting device to operate beyond tolerance in HYVA HA10?
If the load limiting device activates beyond its tolerance limits on your HYVA Construction Equipment, it indicates an incorrect setting of the load limiting device. It is suggested to go to an authorized workshop.
What does it mean if I find metal particles in HYVA HA10 oil filters?
If you find metal particles in the oil filters of your HYVA Construction Equipment, some parts of the hydraulic circuit may be deteriorating. It is suggested to go to an authorized workshop.
Why is rotation blocked in one direction in my HYVA HA10?
If rotation is blocked in one direction on your HYVA Construction Equipment, the slewing limiting device may have been triggered. It is suggested to go to an authorized workshop.
General| Brand | HYVA |
|---|---|
| Model | HA10 |
| Category | Construction Equipment |
| Language | English |
To Next Page
