IAME Parilla x30 125cc RL-TaG - 2.3 EXHAUST HEADER ASSEMBLY; 2.4 PREPARATION AND INSTALLATION OF THE MOTOR-MOUNT

MAN-043/B
11
2.3
EXHAUST HEADER ASSEMBLY
NOTE:
THE ENGINE IS SUPPLIED WITH THE
EXHAUST GASKET AND NUTS ALREADY
INSERTED. WHEN THE SHIPMENT IS MADE
THE INTERNAL PARTS OF THE ENGINE ARE
PROTECTED BY A BLIND GASKET. (SEE FIG.
1).
2.3.1 REMOVE THE NUTS AND THE EXHAUST
COVER.
2.3.2 MAKE SURE THE EXHAUST GASKET IS
IN SEAT AND INSTALL THE EXHAUST
HEADER (SEE FIG 2).
2.3.3 INSTALL THE TWO WASHERS 8mm.
2.3.4 INSTALL THE TWO 2 NUTS M8.
TORQUE AT 18 ÷ 22 Nm (160 ÷190 in-lb)
13mm SOCKET WRENCH OR (13 mm OPEN WRENCH)
PREPARATION AND INSTALLATON OF THE MOTOR-MOUNT
NOTE: ALL THE DIMENSIONS ARE IN MILLIMETERS
2.4
2.4.1 DRILL 4 HOLES (DIAM. 8.25÷8.5mm) IN THE MOTOR-MOUNT .
MOTOR MOUNT HORIZONTAL VIEW
Fig.1
Fig.2