IAME Parilla x30 125cc RL-TaG - 2.5 INSTALL THE CARBURETOR

MAN-043/B
12
2.4.2 INSTALL THE MOTOR-MOUNT, MAKE
SURE TO USE THE M8 ALLEN SCREWS, WITH
A LENGHT SUCH AS TO ENGAGE, IN THE
CRANKCASE, A THREADED LENGHT OF
16÷19mm (THE SCREW MUST PROTRUDE
FROM THE PLATE FOR 16÷19mm ) (SEE FIG.
3 AND DRAW. PAG. 11)
4 ALLEN SCREWS M8–TORQUE AT 22÷24 Nm
(190 ÷ 210 in-lb)
6 mm ALLEN WRENCH
INSTALL THE CARBURETOR
2.5.1 REMOVE THE PLASTIC PLUG FROM THE
INLET MANIFOLD (SEE FIG. 4).
ATTENTION:
MAKE SURE THAT THE PRESSURE HOLE ON
THE GASKET IS NOT PLUGGED.
2.5
2.5.2 INSTALL THE CARBURETOR.
TWO 2 NUTS M6 AND TWO WASHERS
(SEE FIG. 5).
TORQUE AT 6 ÷ 10 Nm (50÷ 90 in-lb)
ATTENTION:
WHEN REPLACING THE CARB GASKET
ALWAYS MAKE SURE THAT THE GASKET IS
INSTALLED SO THAT THE HOLE IN THE
GASKET MATCHES WITH THE TWO
PRESSURE HOLES IN THE CARB. AND IN
THE CRANKCASE: OTHERWISE THE ENGINE
WON’T START.
5 mm ALLEN
Fi
g
.3
Fig.4
Fig.5