INSTALLATION AND OPERATION INSTRUCTIONS
1-4
SFT 199 TANKLESS WATER HEATER
SURFACE
DISTANCE FROM
COMBUSTIBLE
SURFACES
RECOMMENDED DISTANCE
FOR INSTALLATION AND
SERVICE
Front 2" 24"
Rear 0" 0"
Left Side 1.5"
6" (labels may be dif cult to read with
reduced clearance)
Right Side 4"
6" (labels may be dif cult to read with
reduced clearance)
Top 2" 24"
Bottom 8" 24"
Table 2: Clearance from the unit cabinet
You must provide a minimum distance below the water heater of 10"
to allow clearance for the supplied condensation trap assembly. More
clearance will typically be required to accommodate associated water and
gas piping.
Figure 2: Wall mounting of unit
1.3.1 Mobile Home Installations
Units installed in a mobile or manufactured home must conform to the
Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280
and/or CAN/CSA Z240 MH Series, Mobile Homes.
WARNINGS
Exposed water piping and
associated components
(relief valves, circulators, etc.)
should not be in contact with
combustible materials. Check
local codes for required
clearances and/or provide
adequate insulation.
DO NOT MOUNT THIS
UNIT TO HOLLOW WALL
STRUCTURES - The
combined weight of the
unit, its water contents
and associated piping
components can exceed 150
pounds. Fasteners must be
rated for this strain, and must
be rmly anchored into solid
material that will support this
weight.
Take precautions to avoid
injury during the installation
of this unit.
DANGER
Do not common vent the SFT
series water heaters with
any other existing or new
appliance.
To Next Page
Loading...
Need help?
General
