IBM 3270 - Page 224

INDPA
INDP A016 Invalid hex replace data
Explanation: The replace data in the zap line
either contained nonhexadecimal data or was
missing. You may see "Verify is correct" before
getting this message. This indicates that only the
replace data is incorrect.
User Response: Correct the zap data and retry
the operation.
INDPA017 Comma or parenthesis missing
Explanation: You have more than 8 characters
in the verify or replace data line or you haye a
required delimiter missing from the displayed zap
line. You must have left and right parentheses
and two commas in the zap line.
User Response: Correct the zap data and retry.
INDPA020 PATCH = ZAP xxxx
(OF'F = xxxx, VER = xxxx,REP = xxxx)
module not found
Explanation: The module specified in the zap
data was not found during patch data
verification.
User Response:
• If the zap data is incorrect, correct the data
and retry the operation .
• If the data is correct, determine why the
module was not found. There may be:
An incorrect diskette drive specifier or
A deleted module. If a module has been
deleted, use a backup copy and retry the
operation.
Appendix A. Messages A-39