IBM 3270 - Page 241

INDSR
User Response: If you specified a filespec on
the command, check to be sure that it was
specified correctly. Make sure the drive door is
closed.
Enter the DOS directory command, DIR,
to check the personal computer filename and
extension.
Note.~ The SA VE and RESTORE commands
accept four keywords:
• Autokey
• Notepad
• Screen
• Notepadn
If the command is not followed by one of the
above keywords, filespec is the assumed
parameter. Make sure you typed these keywords
correctly.
Make sure the directory or
sub~directory you are attempting to restore from
has the file residing there.
If you find no error in your procedures, follow
your local procedures and have available:
1. The message number.
2. The sequence of events that caused the
failure, including the keys pressed and in
what order.
3. A system level.
A-56 Book 3 -
Using the Control Program