IBM 3270 - Page 83

How to Write the RECEIVE Command
There are several parts to the RECEIVE
command.
o
r~-----"".A.. ...... __ ,
RECEIVE d:path filename. ext h:data set name
o
•
r~------"'.A.. ___ ,
(member name)/password ASCII CRLF APPEND
If you need the parts shown in upper case, type
them exactly as shown. If you need the parts
shown in lower case, you must supply the names
or values that you want.
o RECEIVE The name of the command;
(You
always need this name.)
e d: The diskette reader or fixed
disk on which the data set is to
be placed: a, b, c, or d. (If the
3270 PC Utilities are on a
diskette and the data set is to
be placed onto a separate
diskette, this part must name
drive B. If, in addition, you
have only one diskette drive
and you are told to insert a
diskette into drive B, insert it
into drive A instead. If you
want to put the data set onto
your default drive, this part is
optional.)
7-30 Book 3 - Using the Control Program