To automatically configure the adapter:
1.
From the 5250 Adapter Configuration Menu, select the Change
Adapter Configuration option. The Change Adapter
Configuration screen, similar to the one shown in Figure 21,
appears.
~--------
Ctiange
Adapter Configuration
--------~
Adapter:
IBM
5258 Express
ISA
(Plug-n-Play)
Adapter
I/O
Port
Address: 2718-271F
Memory
Address:
DC08-DDFF
Interrupt
Level: 5
Plug
-n-
Play
BIOS:
Yes
Plug
-n-
Play:
Enabled
Automatic Configuration
Change I/O
Port
Change
Memory
Change
Interrupt
Enable
Pl
ug-n-Play
Disable
Plug-n-Play
Esc=Return Fl=Help
F2=Keys
Help Fl8=Save
Figure 21. Change Adapter Configuration Screen
2.
From the Change Adapter Configuration screen, select the
Automatic Configuration option. The Automatic Configuration
screen, similar to the one shown in Figure 22, appears. This
screen shows you information about the Automatic Configuration
option while the program selects an I/O Port and Memory
Address ranges.
~---------Automatic
Configuration---------~
Now
attempting
to
establish
the
IBM
5258
Emulation Adapter
I/0
port
and
memory
assignments.
If
there are
no
screen changes
after
5 seconds, then
the displayed configuration
has
caused your personal
computer
to
lock up.
If
your personal computer
locks
up, use
the
Change
1/0
Port
and
Change
Memory
options
to
establish
the
adapter
1
s
configuration.
Note:
This option does not assign the adapter's interrupt
level.
Use
the
Change
Interrupt option
to
assign the adapter's
interrupt
level.
l
I/0
Port
Address:
Memory
Address:
2718-271F J
ocee-DDFF
Figure 22. Automatic Configuration Screen
Part
3. Reference
35
To Next Page
Loading...
