Matching AS/400 parameters for a 5494 connected by frame relay
You must coordinate the communications configuration parameters between AS/400 and the 5494
controller connected by frame relay. A description of the parameters are in the following table. Then,
related fields and subfields from the 5494 configuration display and the AS/400 configuration value and the
matching 5494 value. You can coordinate these values automatically or manually. Pick one of these ways:
v To automatically connect the AS/400 to a 5494 controller, you can use the automatic remote controller
(QAUTORMT) system value.
v To manually configure the AS/400 to a 5494 controller:
– See “Example: Connecting an AS/400 to a 5494 controller connected by frame relay” on page 47 for
an example of connecting AS/400 to a 5494 controller by frame relay.
– Use the following table to configure the AS/400 to a 5494 that is connected by frame relay.
For more information about configuring the 5494, see these books:
46 Version 5
To Next Page
Loading...
