IBM BJ0NJML - Service And Asset Management - Labor Transaction Collaboration Switches; Purchase Order Collaboration Switches

Labor Transaction Collaboration Switches
300
Integration Guide
Labor Transaction Collaboration Switches
Purchase Order Collaboration Switches
Process
Control ID
Description Value and Action Derivation of
System ID 1
Derivation of
System ID 2
LTSRC Generate service receipts for POs.
Used when creating labor transactions or
changing status. PO must exist in this system.
0
1
Allow setting value of
LABTRANS.GENAPPRSERVRECEIPT to Y;
configurable in the Application Setup.
Leave value of
LABTRANS.GENAPPRSERVRECEIPT as N.
LABTRANS PO
Process
Control ID
Description Value and Action Derivation of
System ID 1
Derivation of
System ID 2
PODEL Delete POs.
Used when deleting POs. Use only when
deleting then subsequently re-adding a PO
due to changes in the PO.
If any PRLINES contain a reference to the PO,
clear them. If necessary, reopen the PR. When
the PO is re-added, the PRLINEs will be
established again.
0
1
Do not delete PO.
Delete PO and PRLINEs; do not delete
POSTATUS.
“THISMX” PO
POINV Do not allow unreferenced external inventory
for internal POs.
Used when adding or updating PO lines and
changing the status of internal POs.
0
1
If the item-vendor combination not in
INVENTORY table, error.
If item-vendor combination not found in
INVENTORY table (where
PO.VENDOR = LOCATIONS.LOCATION),
ignore error.
PO LOCATIONS,
where vendor is
the storeroom