5. Read the README.txt file that is located on the DS8000 Storage Manager CD
to check for information that might supersede the information in these upgrade
instructions.
6. Type ./setup.linux -silent in the same Command Prompt window in which you
changed the current directory to the root of the CD, to start the DS8000 Storage
Manager upgrade program in unattended (silent) mode.
7. Wait for the DS8000 Storage Manager installation program to install the
product. This can take 5 - 10 minutes.
8. Review the log file for any possible error messages, after the installation
program completes. If there are no errors, the installation program completed
successfully. The log file is located in xxx/logs/install.log, where xxx is the
destination directory where the DS8000 Storage Manager was installed. The
install.log file contains a trace of the installation actions.
9. Perform the postinstallation tasks after the installation has completed. You can
read the instructions for the postinstallation tasks in the postinstallation.txt in
the doc directory on the product CD.
Chapter 3. Installing on the Linux operating system 77
To Next Page
Loading...
Need help?
General
