Table 3. User Group capabilities (continued)
Capability Administrator
Physical
Operator
Logical
Operator
Copy
Services
Operator Monitor
No
Access
Manage Copy
Services
(FlashCopy, remote
mirror and copy,
Global Mirror)
X X X
Set Copy Services
timeout values
X X X
Update user
account password
X X X X X X
Query FRUs and
enclosures
X X X X X
Query
configuration
X X X X X
Query Copy
Services
X X X X X
FRU management X
Problem
management
X
Validate
communication
paths
X
Activate code load X
Create a new PE
package
X
Manage storage
unit IP addresses
X
Adding user accounts
You must have Administrator level privileges to add a new user account. If you do
not have Administrator level privileges, Add does not display in the Select Action
drop-down box of the User administration - Main page. You can also add a user
account with the mkuser DS Command-Line Interface command. See DS CLI
documentation for more information.
1. Under Monitor system, select User administration. In User administration —
Main page, select Add in the Select Action drop-down box. The Add user page
is displayed.
2. Specify the user name. You can enter up to 16 characters.
3. Specify the user account password. This entry is displayed as asterisks.
Passwords must meet the following criteria:
v Be six to 16 characters long.
v Must contain five or more letters, and it must begin and end with a letter.
v Must contain one or more numbers.
v Cannot contain the user’s user ID.
v Is case-sensitive.
Chapter 6. Administering 93
To Next Page
Loading...
Need help?
General
