EasyManuals Logo

IBM DS8000 User Manual

IBM DS8000
250 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
v Linux
v Transaction Processing Facility (TPF)
v Virtual Storage Extended/Enterprise Storage Architecture (VSE/ESA
â„¢
)
v z/OS
v z/VM
®
v z/VSE
â„¢
For the most current information on supported hosts, operating systems, adapters
and switches, see the DS8000 Interoperability Matrix at http://www.ibm.com/
servers/storage/disk/ds8000/
or the System Storage Interoperation Center (SSIC)
at http://www.ibm.com/systems/support/storage/config/ssic/.
FICON-attached System z and S/390 hosts overview
This section describes how you can attach the DS8000 storage unit to
FICON-attached System z and S/390 hosts.
Each storage unit fibre-channel adapter has four ports. Each port has a unique
worldwide port name (WWPN). You can configure the port to operate with the
FICON upper-layer protocol. For FICON, the fibre-channel port supports
connections to a maximum of 509 FICON hosts. On FICON, the fibre-channel
adapter can operate with fabric or point-to-point topologies.
With fibre-channel adapters that are configured for FICON, the storage unit
provides the following configurations:
v Either fabric or point-to-point topologies
v A maximum of 64 host adapter ports on DS8100 Models 921 and 931, and a
maximum of 128 host adapter ports on DS8300 Models 922, 932, 9A2, and 9B2
v A maximum of 509 logins per fibre-channel port
v A maximum of 8192 logins per storage unit
v A maximum of 1280 logical paths on each fibre-channel port
v Access to all 255 control-unit images (8000 CKD devices) over each FICON port
v A maximum of 512 logical paths per control unit image.
Note: FICON host channels limit the number of devices per channel to 16 384. To
fully access 65 280 devices on a storage unit, it is necessary to connect a
minimum of four FICON host channels to the storage unit. You can access
the devices through a switch to a single storage unit FICON port. With this
method, you can expose 64 control-unit images (16 384 devices) to each host
channel.
The storage unit supports the following operating systems for System z and S/390
hosts:
v Linux
v Transaction Processing Facility (TPF)
v Virtual Storage Extended/Enterprise Storage Architecture (VSE/ESA)
v z/OS
v z/VM
v z/VSE
For
the most current information on supported hosts, operating systems, adapters
and switches, see the DS8000 Interoperability Matrix at http://www.ibm.com/
18 DS8000 User’s Guide
|
|
|
|
|
|
|
|
|

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM DS8000 and is the answer not in the manual?

IBM DS8000 Specifications

General IconGeneral
Data EncryptionYes
High AvailabilityYes
Drive TypesSSD, HDD
RAID SupportRAID 5, RAID 6, RAID 10
InterfaceFICON, Fibre Channel, iSCSI
Form FactorRack-mountable
Operating Systems SupportedIBM z/OS, IBM i, AIX, Linux, Windows
ModelDS8000 series
ScalabilityHighly scalable

Related product manuals