Chapter 4. Replace power supply in iSeries 825
To perform this procedure with the system powered on, you must have two power
supplies and two working air moving devices. If you need to replace an air
moving device, go to Chapter 6, “Replace the air moving device,” on page 13.
To replace the power supply, perform these tasks:
Note: The figures in these instructions may not look exactly like the server that
you have. However, the steps to perform the task are the same.
__ 1. Perform prerequisite tasks as described in Chapter 2, “Before you begin,”
on page 3.
__ 2. If you need to power down the system, follow the steps in “Power down
the system” on page 23.
__ 3. Remove the back cover. Refer to “825 back cover” on page 20.
__ 4. Locate the power supply to be replaced at the back of the unit (P01 or
P02).
© Copyright IBM Corp. 2000, 2005 7
To Next Page
Loading...
