3. Position the cover on the chassis so that the rail guides on the bottom of the
cover engage the rails and push the cover closed until it latches.
4. Reconnect the external cables and power cords to the computer. See “Installing
external options” on page 58.
5. To update the configuration, see Chapter 5, “Using the IBM Setup Utility
program” on page 77.
Important:
When the power cord is first plugged in, the computer might appear to turn
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.
Chapter 4. Types 8307, 8308, 8310, 8311, 8314, and 8315 75
To Next Page
Loading...
