8 I SERVPROC 12/18/03 10:09:25 Ethernet[0] Link Established at 100Mb, Full Duplex.
9 I SERVPROC 12/18/03 10:09:24 Ethernet[0] configured to do Auto Speed/Auto Duplex.
10 I SERVPROC 12/18/03 10:09:24 Ethernet[0] MAC Address currently
being used: 0x00-09-6B-CA-0C-80
x345RSA>
syshealth command
Description
Use the syshealth command to get a summary of the health of the server. The
power state, system state, restart count, and Remote Supervisor Adapter II software
status are displayed.
Example
x345RSA> syshealth
Power On
State System power off/State unknown
DD not active
Restarts 0
x345RSA>
temps command
Description
Use the temps command to display all the temperatures and temperature
thresholds. The same set of temperatures are displayed as in the Web interface.
Example
x345RSA> temps
Temperatures are displayed in degrees Fahrenheit/Celsius
WR W T SS HS
----------------------------------------
CPU1 65/18 72/22 80/27 85/29 90/32
CPU2 58/14 72/22 80/27 85/29 9/320
DASD1 66/19 73/23 82/28 88/31 9/332
Amb 59/15 70/21 83/28 90/32 9/355
x345RSA>
Notes:
1. The output has the following column headings:
WR: warning reset
W: warning
T: temperature (current value)
SS: soft shutdown
HS: hard shutdown
2.
All temperature values are in degrees Fahrenheit/Celsius
volts command
Description
Use the volts command to display all the voltages and voltage thresholds. The
same set of voltages are displayed as in the Web interface.
Example
x345RSA> volts
HSL SSL WL WRL V WRH WH SSH HSH
----------------------------------------------------------
5v 5.02 4.00 4.15 4.50 4.60 5.25 5.50 5.75 6.00
Chapter 6. Command-line interface 95
To Next Page
Loading...
