IBM Remote Supervisor Adapter II - Configuration Commands; Dhcpinfo Command

Description
Use the console command to start a serial redirect console session to the
designated serial port of the Remote Supervisor Adapter II or the Remote
Supervisor Adapter II SlimLine.
Configuration commands
The configuration commands are as follows:
v dhcpinfo
v ifconfig
v ldap
v ntp
v passwordcfg
v portcfg
v slp
v srcfg
v ssl
v tcpcmdmode
v timeouts
v users
dhcpinfo command
Syntax
dhcpinfo eth0
Description
Use the dhcpinfo command to view the DHCP server-assigned IP configuration for
eth0, if the interface is configured automatically by a DHCP server. You can use the
ifconfig command to enable or disable DHCP.
Example
x345RSA> dhcpinfo eth0
-server 192.168.70.29
-n ASMA00096B9E003A
-i 192.168.70.202
-g 192.168.70.29
-s 255.255.255.0
-d linux-sp.raleigh.ibm.com
-dns1 192.168.70.29
-dns2 0.0.0.0
-dns3 0.0.0.0
x345RSA>
The following table describes the output from the example.
Option Description
-server DHCP server that assigned the configuration
-n Assigned host name
-i Assigned IP address
-g Assigned gateway address
-s Assigned subnet mask
98 Remote Supervisor Adapter II SlimLine and Remote Supervisor Adapter II: User’s Guide