Note: By default, the Remote Supervisor Adapter II is configured with one login
profile that enables remote access using a login user ID of USERID and a
password of PASSW0RD (the 0 is a zero, not the letter O). To avoid a
potential security exposure, change this default login profile during the
initial setup of the Remote Supervisor Adapter II.
3. Click one of the unused login profile links. An individual profile page similar to
the one in the following illustration is displayed.
4. In the Login ID field, type the name of the profile.
You can type a maximum of 15 characters in the Login ID field. Valid
characters are uppercase and lowercase letters, numbers, periods, and
underscores.
Chapter 3. Configuring the Remote Supervisor Adapter II 19
To Next Page
Loading...
