IBM SAN Volume Controller 2145 - Rack installation procedures

Installing support rails for the control enclosure
Before you install the control enclosure, you must rst install the support rails for it.
Procedure
To install the support rails for the control enclosure, complete the following steps.
1. Locate the control enclosure rails (Figure 1 on page 14).
The rail assembly consists of two rails that must be installed in the rack cabinet.
Figure 1. Control enclosure support rails
2. Working at the front of the rack cabinet, identify the two standard rack units (2U) of space in the rack
into which you want to install the support rails.
Figure 2 on page 15 shows two rack units with the front mounting holes identied.
14
SAN Volume Controller 8.3.1: Machine Types 2145, 2147 Models SA2, SV2