c) If you already use IBM Storage Insights, log in to Storage Insights, select Add Storage System and
register the new system by using the IP address.
Important: If you do not use IBM Storage Insights, you were registered during the initial system
setup. When your Storage Insights interface is ready to use, you receive an email notication. IBM
®
Storage Insights is an IBM Cloud
™™
software as a service offering that can help you monitor and
optimize the storage resources in the system and across your data center.
d) If errors exist, you are prompted to resolve them.
e) Review the system summary page, then click Finish.
The Initial Setup Wizard closes.
3. If there is more than one control enclosure for your system, go to Monitoring > System > System--
Overview and click Add Enclosure.
Add Enclosure is shown only when a candidate control enclosure exists.
4. Use the System update page of the management GUI to check whether software updates are
available for this system. Use the management GUI to help you install any updates.
During the automatic update process, each node canister in the system is updated one at a time. After
all the nodes in the system are successfully restarted with the new code level, the new level is
automatically committed.
5. Start the wizard to congure drives and pools.
6. Referring to the Call Home and Storage Insights conguration worksheet, use the following URL to
register the new system:
https://call-home.w3ibm.mybluemix.net/activate
7. If you activated an encryption license, click Enable Encryption to complete the encryption setup
wizard.
8. If exactly two control enclosures are in the system, you must set up a quorum disk or application
outside of the system. If the two control enclosures lose communication with each other, the quorum
disk prevents both I/O groups from going offline. For more information, see the "Conguring quorum"
topic in the IBM Knowledge Center.
Results
You completed the initial setup of your system as the nal part of installation.
What to do next
You are ready to migrate data from another system and congure your system.
Chapter 2. Installation
21
To Next Page
Loading...
Need help?
General