3504/3505 Stop Indications
and
Restart
Procedures
(cont'd)
INDICATION DISPLAYED: JAM, TRANSPORT, CHECK CARD, HOPPER
REPLACE 1
RECOVERY PROCEDURE:
1.
Locate
and remove
the
card from
the
transport.
2.
Check
the
card
for
damaged edges.
3. Repair
or
reproduce
the
card,
if
necessary.
4.
Place
the
card
in
the
hopper.
5. Press
the
start
key and end·of·file key.
NOTE:
The
permanent
error
key
is
operative during this stop.
INDICATION DISPLAYED: FORMAT RESET
RECOVERY
PROCEDURE:
Indicates
that
an
optical mark read
or
read
column
eliminate
format
has been
reset
by
an
unformatted
read
only
command
or
by an
unformatted
read, feed and
select stacker command. If this
error
occurs within a job, and
if
the
operator
has
no
other
information from
the
programmer,
the
operator
should press
the
stop
key,
permanent
error key,
then
the
start
key
to
make
the
device ready. If this
error
occurs
within a
job
and
the
programmer has provided
operator
instructions,
the
operator
should follow these instructions. If this
error
occurs
at
job initiation,
the
operator
should NPRO, place the last
two
cards entering
the
active side
of
stacker 1 in correct sequence under
the
cards in
the
hopper, close
the
hopper
door,
and
press
the
start
key.
INDICATION DISPLAYED: NPRO. PERMANENT
ERROR
RECOVERY PROCEDURE:
This
is
a device
permanent
error
-
command
reject.
1.
Perform
the
error
recovery specified by
the
source program
for
this
type
of
error.
INDICATION t DISPLAYED: JAM, TRANSPORT, PERMANENT ERROR
RECOVERY
PROCEDURE:
This
is
a device
permanent
error.
1.
If
the
reader has a log-out key, press it
and
write
down
the
digits from
l'aCh
rO\lll
of
the
backlighted panel.
2. I f
the
reader has no log·out key, record
the
error information from
the
reader log display
at
the
system console.
3. When you
report
the
problem
to
the
CE, also
report
the
error informa·
tion
you
recorded.
INDICATION DISPLAYED: JAM, MACHINE CHECK, PERMANENT
ERROR
RECOVERY PROCEDURE:
Consider
this
a
permanent
error
condition
and perform
the
procedure specified by
the
source program. During this procedure
the
NPRO
key
should
be
pressed with
the
hopper
door
open
to
run cards
out
of
the
unit.
Page
5·16
To Next Page
Loading...
