IBM System/370 - Page 173

3525 Stop Indications and Restart Procedures
Source: GA21-9124-3 3505 Card Reader 3525 Card Punch
Subsystem Component Description
CHIP
STACKER
COVER FEED
BOX
OPEN
OPEN
CHECK
PRESS
FORMAT. 3 CARD
CARD
8
START 4 RESE1 2
RUN IN
NPRO
JAM
MACHINE PERM
8
4
CHECK 2.
ERROR 1
OFFLINE
MIS·
STACKER PRINT
SELECT 3
SKEW
If indicators are not in a combination shown on any error display, or if an
operator recovery action is unsuccessful, treat the condition as a permanent error
and perform the procedure specified by the source program.
INDICATION DISPLAYED: CHIP BOX
RECOVERY PROCEDURE:
1. Remove and empty the chip box.
2. Place the chip box back into the machine.
NOTE: After the chip box light comes on, the punch continues to operate
for a reasonable period of time if the box is in the machine and properly
positioned. However, when the chip box becomes too full to permit machine
operation, the operator call light will come on and the punch will stop.
NOTE: Chip box must
be in the tray.
J1
RIGHT WRONG
NOTE: The permanent error key is operative during this stop.
Page 5-17