3525
Stop Indications and Restart Procedures (cont'd)
INDICATION DISPLAYED: STACKER
RECOVERY PROCEDURE:
1.
Empty
the
full stacker.
2. Press
the
start
key.
NOTE: If
the
stacker light
is
on
and neither stacker 1
nor
stacker 2
is
full,
check
for
the
reject
stacker being full.
NOTE:
The
permanent
error key
is
operative during this stop.
INDICATION DISPLAYED: COVER OPEN
RECOVERY PROCEDURE:
1.
Close any cover
that
is
open.
2. Press
the
start
key.
NOTE:
The
permanent error key
is
operative during this stop.
INDICATIO~
DISPLAYED: FEED OPEN
RECOVERY PROCEDURE:
1.
Make sure upper read head
is
latched.
2.
Close and latch
the
feed mechanism.
3.
Press
tile
starr
key.
NOTE:
The
permanent error key
is
operative during this stop.
INDICATION DISPLAYED: JAM, 3 CARD RUN
IN
RECOVERY PROCEDURE:
Page
5·18
1.
Remove cards from
the
transport
manually, keeping them
in
sequence.
2. Repair
or
reproduce any damaged cards offline; reassemble cards
in
correct
sequence and place them with undamaged cards.
3. • If 3 CARD RUN
IN
is
blinking, place
the
last two cards below
the
cards
in
the
hopper and discard
the
preceding card.
If
3 CARD
RUN
IN
is
not
blinking, place last three cares below
cards
in
hopper.
4.
Place remaining cards in
COHee!
stacker
or
Slackers.
5.
Press
the
start
key.
NOTE:
The
permanent error
k~y
is
operative during this stop.
To Next Page
Loading...
