IBM System i User Manual

Connecting the power cords
__ If your server is equipped with a retention bracket, route the power cord under the bracket before you
plug it into the back of the server as shown here:
__ Plug the power cords into the system, display, and attached devices.
Starting your workstation
__ Power the system on.
Note: Expect a delay between the time that the power is applied to the server or workstation and the time that
an initial program load (IPL) can be performed. When power is initially applied to the server or workstation, the
service processor performs a self-check and leaves the control panel blank for up to two minutes. You must wait
until the C1XX XXXX progress codes are complete and the control panel displays 01 before you perform an IPL or
change the control panel functions.
After you finish
_ Return to your initial setup checklist and complete the next step.
Related concepts
Installing features and replacing parts
Related tasks
Accessing the ASMI using a Web browser
Accessing the ASMI using an ASCII terminal
Powering the system on and off
Related reference
References
Related information
Adapters, Devices, and Cable Information for Multiple Bus Systems
Cabling a 9111-285 and the Hardware Management Console (HMC)
Learn how to cable the expansion units, connect the external cables, power cords, and HMC cables, attach
devices, and route the cables after you install all of your hardware features or replace parts.
Cabling your server 137

IBM System i Specifications

General

Operating System	IBM i
Form Factor	Rackmount, Tower
Processor	POWER5, POWER6, POWER7, POWER8, POWER9
Security	encryption
Networking	Ethernet
Reliability	redundant components
CPU	POWER processors
Memory	Up to several terabytes depending on model

Summary

Safety and Environmental Notices

Laser Safety Information

Details on laser safety precautions and compliance for IBM servers.

Product Recycling and Disposal

Guidelines for responsible recycling and disposal of IBM IT equipment.

About this Publication

Cabling Your Server

Accessing the Advanced System Management Interface (ASMI)

Accessing and using the ASMI for service processor tasks and system management.

Using the Hardware Management Console (HMC)

Using the HMC for managing hardware tasks and configuring logical partitions.

Connecting Server Power Cords

Instructions for routing and connecting server power cords safely and securely.

Server Startup Procedures

Procedures for powering on the server and initial system startup checks.