IBM System i User Manual

After you finish
__ Did you receive a cable hook with your rack shipment?
v No. Proceed to the next item.
v Yes. The cable hook manages the server cables in the back of the rack. To install the cable hook, slide it into
the slots that are located on the back of the rack as shown here:
__ Return to your initial server setup checklist and complete the next step.
Cabling your server 189

IBM System i Specifications

General

Operating System	IBM i
Form Factor	Rackmount, Tower
Processor	POWER5, POWER6, POWER7, POWER8, POWER9
Security	encryption
Networking	Ethernet
Reliability	redundant components
CPU	POWER processors
Memory	Up to several terabytes depending on model

Summary

Safety and Environmental Notices

Laser Safety Information

Details on laser safety precautions and compliance for IBM servers.

Product Recycling and Disposal

Guidelines for responsible recycling and disposal of IBM IT equipment.

About this Publication

Cabling Your Server

Accessing the Advanced System Management Interface (ASMI)

Accessing and using the ASMI for service processor tasks and system management.

Using the Hardware Management Console (HMC)

Using the HMC for managing hardware tasks and configuring logical partitions.

Connecting Server Power Cords

Instructions for routing and connecting server power cords safely and securely.

Server Startup Procedures

Procedures for powering on the server and initial system startup checks.