IBM System i User Manual

Connecting the power cords
__ If your server is equipped with a retention ring, route the power cord through the ring before you plug
it into the back of the server, as shown here:
__ If your server is equipped with a retention bracket, route the power cord under the bracket before you
plug it into the back of the server, as shown here:
__ Are you installing an uninterruptible power supply?
__ No. Connect the server power cords to the server. Do not plug the power cord into the power outlet. Do
not start your server.
__ Yes. To complete the installation of the uninterruptible power supply, see the Powerware Web site.
Cabling your server 29

IBM System i Specifications

General

Operating System	IBM i
Form Factor	Rackmount, Tower
Processor	POWER5, POWER6, POWER7, POWER8, POWER9
Security	encryption
Networking	Ethernet
Reliability	redundant components
CPU	POWER processors
Memory	Up to several terabytes depending on model