RELATED SERVICE INFORMATION
Hibernation mode
Note for the Windows NT
A Windows NT user cannot create a hibernation file in
a Windows NT system that uses the NTFS format
system, the Windows NT default format. If you want
to use hibernation mode, you should reinstall Windows
NT with a FAT format system.
In hibernation mode, the following occurs:
The system status, RAM, VRAM, and setup data are
stored on the hard disk.
The system is powered off.
Any one of the following events causes the computer to
enter hibernation mode:
The Fn + F12 keys are pressed.
The Hibernation button is selected in the Fuel-Gauge
program.
The power switch is turned off and hibernation mode
is set to Power switch mode [Hibernation].
The timer conditions are satisfied in suspend mode
(for operating systems other than Windows 98).
A critically low battery condition occurs and
hibernation mode is set to Hibernate when battery
becomes low.
The computer leaves hibernation mode and resumes
operation when the power is turned on. The hibernation
file in the boot record on the hard disk drive is read, and
system status is restored from the hard disk drive.
Notes:
1. In the ThinkPad Configuration program, the
computer can be set to suspend/hibernate
while docked.
2. The computer cannot enter hibernation mode
when it is powered with ac power and a
communication PC Card is used.
7
To Next Page
Loading...
Need help?
General
