22
i
If your computer has
previously been used with
a CRT monitor and is currently
configured to a display mode
outside the range that the Flat
Panel monitor can display, you
may need to re-attach the CRT
monitor temporarily until you
have reconfigured the
computer, preferably to 1280 x
1024 at 60Hz.
The display mode the monitor uses is controlled by the computer.
Therefore, you should refer to your computer documentation for details on
how to change display modes.
The image size, position and shape may change when the display mode
changes. This is normal and the image can be readjusted using Image
setup and the monitor controls.
Unlike CRT monitors, which require a high refresh rate to minimize flicker,
TFT technology is inherently flicker-free. If possible, configure your
computer for 1280 x 1024 addressability at 60Hz vertical refresh rate.
For the display modes listed below, the screen image has been optimized
during manufacture.
Factory set display modes
Further information
Display modes
Addressability
Refresh rate Horizontal frequency
640 x 350 70.8 Hz 31.5 kHz
640 x 480 59.9 Hz 31.5 kHz
640 x 480 66.6 Hz 35.0 kHz
640 x 480 72.8 Hz 37.8 kHz
640 x 480 75.0 Hz 37.5 kHz
720 x 400 70.1 Hz 31.5 kHz
800 x 600 60.3 Hz 37.8 kHz
800 x 600 72.1 Hz 48.0 kHz
800 x 600 75.0 Hz 46.8 kHz
832 x 624 74.5 Hz 49.7 kHz
1024 x 768 60.0 Hz 48.3 kHz
1024 x 768 70.0 Hz 56.4 kHz
1024 x 768 75.0 Hz 60.1 kHz
1024 x 768 74.9 Hz 60.2 kHz
1152 x 864 75.0 Hz 67.5 kHz
1152 x 870 75.0 Hz 68.6 kHz
1152 x 900 65.9 Hz 61.8 kHz
1280 x 960 60.0 Hz 60.0 kHz
1280 x 1024 † 60.0 Hz 63.9 kHz
1280 x 1024 72.0 Hz 78.1 kHz
1280 x 1024 75.0 Hz 79.9 kHz
† Recommended
Note: VESA timings are as
detailed in the VESA
“Display Monitor Timing
Specification”. Version 1.0,
Revision 0.8, Dated
09/17/98.
To Next Page
Loading...
Need help?
General
