EasyManua.ls Logo

IBO PC-59 - Page 18

IBO PC-59
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
Safety of use | rules relating to security
This manual has been created with the users in mind to facilitate the correct operation of
the machine type: PC-59. The information contained in this manual is subject to change
without prior notice.
To ensure correct and safe use of the machine type: PC-59 and to avoid possible damage to
the pump or dangerous situations for users, please read the following instructions carefully
before installing and operating the device.
Install on metal or other non-ammable materials. There is a risk of re.
Use away from ammable materials. There is a risk of re.
Use away from explosives. There is a risk of an explosion.
Check that the grounding is correct and eective. Defective or incorrect grounding
can cause electric shock.
Check that the power supply complies with the instructions. Failure to do so may
result in electric shock or re.
Turn o the electricity supply before installation or maintenance. Otherwise, there
is a risk of electric shock.
Do not touch the controller with wet hands. There is a risk of electric shock.
If the device is not in use for more than 2 years, be alert and attentive during start-up.
Upon detection of any abnormal behavior of the device, disconnect it from the
power supply immediately.
Otherwise it may result in electric shock or re.
Maintenance should begin no earlier than 5 minutes after the power is turned o,
when all the control LEDs are o. There is a risk of electric shock
Do not touch any parts in the electrical system with your bare hands when the device
is connected to the electricity supply. There is a risk of electric shock
The replacement of subassemblies or parts may only be performed by an authorized
service center!
No metal objects may be left in the device. There is a risk of electric shock or re.
Exposed parts of the electronic system should be covered with electrical tape. There
is a risk of electric shock.
When installing the driver, make sure that the place where it will be installed is
strong enough to support its weight. It may fall and cause property damage or injury.