33
OPERATION INSTRUCTIONS
PREPARING THE EQUIPMENT
The SELECT switch allows you to select the parameters
necessary for the treatment. Press SELECT switch up or
down to move the indicating arrow to the next parameter or
return to the previous parameter.
The SET switch allows the selection of values of each para
meter necessary for treatment. Press the SET switch up or
down to select the values.
Selection of parameters
Programming treatment time
The intensity of ultrasound may be increased or decreased
at any time during the session. After pressing the START
key press the UP or DOWN switch up or down, respectively.
Intensity of ultrasound
Program the desired session time. At the end of the
programmed time, you will hear a sound beep indicating that
the treatment session has been nalized. Press the STOP
switch, so that the sound beep is discontinued. The equipment
will return to the programming status.
Initiating Treatment
Press the START switch to
initiate treatment.
Stopping Treatment
Press the STOP switch to
inalize therapy.
To Next Page
Loading...