Icar 5LSA - Connecting Cable; Description; General Characteristics; Operation

50
3. CONNECTING CABLE
3.1 DESCRIPTION
The cable includes a RS232/TTL converter, which allows converting the TTL signals, in-
coming and outgoing via the rear connector of the controllers, into an isolated RS232 sig-
nal, connectable to a PC. It is designed so that the set-up and the customising of func-
tions of such devices can be achieved, via the appropriate software, on controllers pro-
vided with relative communication port connector.
3.2 GENERAL CHARACTERISTICS
− RS232/TTL isolated interface
− Interface supply derived from the controller
− Connection to PC by SUB-D 9-pin female connector.
3.3 OPERATION
Connect the RJ6/6 phone jack to the controller and the SUB-D 9-pole connector to the PC
serial port.
By installing and opening the programming software, check if the connection is working
correctly.
3.4 TECHNICAL CHARACTERISTICS
Maximum communication speed 19200 baud
Insulation between RS232/TTl 2.5kVAC per 1min
Operating temperature -10… +50°C
Storage temperature -30… +80°C
Degree of protection IP00
Connector to PC 9-pin SUB-D female
Connector to controller RJ 6/6
Total cable length <3m
Converter dimensions WxHxD 18x18x70mm
Reference standards
IEC/EN 60950 (2001)
EN 55022 (1998)+A1
EN 61000-4-3 (1995)+A1
EN 61000-4-2(1998)+A1/A2
EN 61000-4-6 (1996)+A1
EN 61000-4-4 (1995)+A1
EN 61000-4-8 (1994)+A1
EN 61000-4-5 (1995)+A1