Removal of the visor
• Place the helmet onto a table, ensuring that it is entirely stable, and lower the visor into its position of
normal use.
• Unscrew and remove the two pinlock screws that determine the visor’s travel between the open and
closed positions.
• Unscrew the two lateral fixing screws and remove them along with the aluminium washer.
• If you decide to fly without a visor, cover the threaded bushes in the shell using the stickers provided.
Fixing the visor to the helmet
On each side of the outer shell, there are two holes with threaded bushes, one in front for the pinlock screw,
and one behind for the visor pivot.
• Place the helmet onto a table on its side, ensuring that it is entirely stable, with cushioning as
appropriate.
• Working on one side, place the flat plastic washer over the front threaded hole.
• Slide the pinlock screw into the other plastic washer with the chamfered hole.
• Slice the pinlock screw and washer through the arc-shaped travel slot on the visor, through the flat
washer and into the threaded hole, and screw down using a hex key.
To Next Page
Loading...