• INTERNAL POLYSTYRENE PARTS SHOULD NEVER BE MODIFIED OR REMOVED.
• NEVER APPLY PETROL, DILUENTS, TOLUENE OR OTHER SOLVENTS OR CHEMICAL
SUBSTANCES TO ANY PART OF THE HELMET.
Personalization
Removal and reassembly of internal padding
Important: do not use sharp or pointed tools such as screwdrivers, etc., unless absolutely necessary,
in order to prevent scratching or damaging the helmet and its structural components
TZ’s internal padding pieces can be removed and replaced for washing or for varying the helmet size.
The padding is fixed to the polystyrene inner shell by means of a series of Velcro strips. It is easy to remove.
Just ensure that you detach the padding from the Velcro strips gently.
Reassembly
When reassembling the padding, ensure that it is positioned centrally and symmetrically.
When you are sure that the padding is in the correct position inside the helmet, press it down over the Velcro
fastening strips in order to fasten the lining.
Visor installation and removal
The visor can be removed if it has to be cleaned thoroughly or replaced, or if you have purchased a new visor
for your TZ helmet.
Important:
Don’t touch a mirror-finish visor with your hands, because it may be opacified by the acid contained in
perspiration.
Adding or replacing a visor on a TZ helmet:
The visor is supplied with the two screws and aluminium washer, and the two pinlock screws with plastic
washers, needed for assembly.
To Next Page
Loading...