• Position the large screw into the aluminium washer and onto the corresponding hole in the visor, and
screw down into the threaded hole in the outer shell of the helmet.
• Follow the same procedure for the other side of the helmet.
• Adjust the pinlock screw to attain the desired level of friction.
Cleaning
External shell
• Remove the visor, ear defenders and other accessories. Use only a damp microfibre cloth for
cleaning. If the external shell is soiled with mud, insects etc., soak a microfibre cloth with warm water,
wring out excess water, place on the helmet and leave for a few minutes. This will loosen the grime.
Use damp microfibre cloths to gently clean the outer surface of the helmet. Dry with a dry microfibre
cloth. Do not use solvents, chemicals or petroleum-based products which may cause damage to
the helmet’s structure.
• Reassemble the helmet, above all the ear defenders which are essential for the helmet’s certification.
Internal parts
Interior polystyrene
• Use only a damp cloth.
• Leave to dry at room temperature, protected from direct sunlight.
Internal padding
• Hand-wash carefully, using just water at maximum 30° C and neutral soap.
• Rinse in cold water.
• Leave to dry at room temperature, protected from direct sunlight.
To Next Page
Loading...