EN
22
4) As shown in the figure below, make sure that the parking brake is
switched on and the shift lever is in N gear. Operate the clutch as required
when the engine is running.
5) Press the [OK] to next step until the calibration is successful, fully depress
the clutch pedal, select neutral and release the clutch pedal.
6) The screen prompts that the application is complete, and press [OK] to
exit.
6.2.3 BMS
Battery Management System (BMS), registers new battery to the BMS
while battery replacement (Take LandRover as a sample).
If the vehicle has replaced the battery and needs to replace the battery,
this program will reset the stored internal battery monitoring data.
1) Select the "BMS" icon in the service function icon, Select the correct
To Next Page
Loading...
