ICE COBOTICS RS20 - Preventative Maintenance

ICE COBOTICS RS20 10
OPERATOR MANUAL
WARNING: Before performing any
maintenance on the machine, be sure that
the power is turned o󰀨, or the batteries are
disconnected!
WARING: Repairs are to be completed
by Authorized service centers only. Any repairs
completed by unauthorized persons will avoid
the warrenty.
DAILY MAINTENANCE
1. Remove pad driver/ brush and clean with
approved cleaner.
2. Drain recovery and solution tanks completely
and rinse out with clean water. Visually check
the recovery tank for debris and clean out as
necessary.
3. Raise the squeegee assembly o󰀨 oor and wipe
it down with a damp towel. Be sure to store the
squeegee in the up position.
4. Remove the vacuum fan inlet lter and rinse it
out with clean water.
5. Clean machine with an approved cleaner and a
damp towel.
6. Recharge the batteries.
7. Check the condition of the squeegee blade
wiping edge, rotate blade if worn.
MONTHLY MAINTENANCE
1. Clean the battery tops to prevent corrosion.
2. Check for loose battery cable connections.
3. Inspect and clean the recovery tank cover seal.
Replce it if damaged.
4. Lubricate all grease points and pivot points with
silicon spray and approved grease.
5. Check the machine for loose nuts and bolts.
6. Check the machine for leaks.
7.Check and clean solution and recovery tank
lters.
8.Lithium-ion battery must be stored in a charged
state, please charge monthly.
MACHINE STORAGE
1. Always store the machine indoors.
2. Always store the machine in a dry area.
3. Always store the machine in its upright position.
4. Always store the machine with the pad driver/
brush raised o󰀨 the oor.
5. Always store the machine with the squeegee
assembly raised o󰀨 the oor.
6. If storing in an area which may reach freezing
temperatures, be sure to drain all uids from the
machine prior to storage. Any damage caused
by freezing temperatures will not be covered by
the warranty.
7. Drain the recovery tank.
8. Drain the solution tank of all uid.
PREVENTATIVE MAINTENANCE
FAULT CODE & SOLUTION
The machine is equipped with a LED display
screen (see Machine components, item # 13), the
LED screen will display the operating hours (see
Machine components, item # 29) and the battery
level status (see Machine components, item # 32).
When the machine detects a fault, there will be a
Fault code (see Machine components, item #13)
& Fault message display on the LED screen, will
ash continuously, accompany an audible alarm
Occasionally.
Once fault occuring, please DO NOT continue
operate the machine unless the fault are eliminated.
Turn o󰀨 the machine, then to solve the fault, the
fault code & message will be eliminated when
machine restart.
If the fault is occurred frequently, or the fault can't
be eliminated, please contact ICE COBOTICS
service center.
Please refer to the below table to determine the
fault cause and the solution.