ICE COBOTICS RS20 - Machine Operation

7 ICE COBOTICS RS20
OPERATOR MANUAL
WARNING: Do not put any ammable
materials into solution tank. this can cause an
explosion or a re.
FILLING THE DETERGENT BOTTLE
The machine is equipped with a 4 liters Detergent
bottle (machine components, #22). Open the Cap
(machine components, #22) you can ll detergent.
The ratio of water and detergent is 0~5%, you can
adjust this ratio via pressing the Detergent dosage
adjusting buttons (machine components, #37).
water and detergent information as follows
：
Water information of RS20
Water level
1 2 3
Water
500ml/0.13Gal 1000ml/0.26Gal 1500ml/0.40Gal
Water and Detergent information of RS20
Detergent
level
1 2 3
Water
level
Detergent
4g/0.14oz 8g/0.28oz 12g/0.42oz
1
8g/0.28oz 15.5g/0.55oz 23.5g/0.83oz
2
15.5g/0.55oz 31g/1.09oz 47g/1.66oz
3
NOTE: Only use recommended cleaning
chemicals. Contact your janitorial supply
distributor for recommendations on
properchemicals.
WARNING: Do not operate machine
unless you have read and understand this
manual.
PRE-OPERATION CHECKS
1. Check the tank cover seals for damage.
2. Drain the recovery tank, check the vacuum fan
inlet lter, clean them if necessary.
3. Check the vacuum hose for debris or blockage.
4. Check the squeegees for damage, wear and for
deection adjustment.
5. Check whether Pad/Brush is installed properly .
6. Check the accelerator and steering for proper
operation.
OPERATION THE MACHINE
1. Automatic unlocking of seat self-locking safety
switch.
NOTE: The machine will not travel unless the
operator is sitting in the operator seat.
2. After long press the start switch (machine
component #19) for 3 seconds, after the screen
lights up, long press the forward/back button
(machine component #26) and one-click start
(machine component #35) at the same time
for 3 seconds to complete the boot. check the
display(machine components, #13) , if there are
fault codes and the Fault indicator and blinks,
is blink, please Do Not operation the machine
unless the faults have been eliminated (please
see FAULT CODES AND ELIMINATE section).
3. Select a suitable working mode by selecting the
working mode button. This the machine has two
modes of operation: ECO energy saving, and
user-dened mode.
NOTE: To energy saving, recommend to
using the ECO mode as possible.
For the User custom mode, you can select
the preferred settings by pressing the
Solution ow adjusting button (Machine
components,#38), Detergent adjusting button
(Machine components, #37), select the
appropriate parameters to work with.
4. Turn on the 1-Step switch, the Scrub head
assembly and the Squeegee assembly will
lower down automatically, all the presetting
functions will turn on.
5. The machine can scrub in both forward and
backward, press the Directional button (Machine
components, #26) to select the direction.
The horn will sound and the squeegee will
raise automatically (the vacuum motor will turn
o󰀨 after a short delay) when drive machine
backwards. This is to prevents damaging the
squeegee.
NOTE: Go slow when drive machine backwards.
6. The machine can implement a single brush
without suction working mode by pressing a key
After the start button (machine component #35),
press the suction pump switch Button (machine
component #39) to turn o󰀨 suction pump.
When the machine is working backward, the
wiper assembly will automatically rise to avoid
damage Bad scratch, buzzer alarm.
MACHINE OPERATION