ICE COBOTICS RS20 - While Operating Machine

ICE COBOTICS RS20 8
OPERATOR MANUAL
7. Press the Propel pedal, the machine start
scrubbing, the speed can be adjusted by
controlling the force of foot stepping, light is
slow, heavy is fast.
NOTE: Go slow on inclines and slippery
surfaces.
8. To stop scrubbing, turn o󰀨 the 1-Step switch,
the scrub head will raise automatically, the
squeegee will also raise after a short delay (the
vacuum indicator ashing), please keep moving
until the dirty water is picked up, and then
release the propel pedal and stop scrubbing.
9. Hold down the 1-button start switch for 3
seconds to turn o󰀨 the power supply of the
machine.
10. If the machine stops working, it will
automatically shut down after standing still for
12 minutes.
BRAKE DEVICE
The machine is driven by the rear wheel (machine
component #11), on the rear drive wheel, There's
an electromagnetic brake. When the operator
releases the drive pedal, the machine Will stop
the progress, the electromagnetic brake after a
moment of delay, automatically brake the rear
Drive wheels, parking brakes.
EMERGENCY STOP BUTTON
The machine is equipped with an Emergency stop
button (machine components, #17), please push
it if an emergency, that will shut o󰀨 all power of
machine and brake immediately.
To restart the machine, please reset the
Emergency stop button, and turn o󰀨 the machine
and then restart.
NOTE: Please hold the steering wheel when
emergency stop.
WARNING: Fire Or Explosion Hazard. Do
Not Pick Up Flammable Materials Or Reactive
Metals.
1. Go slow on inclines and slippery surfaces, go
slow when turn and reverse. Do not operate the
machine on inclines that exceed 7% (4°).
2. Drive machine in a straight path as possible,
avoid turning the Steering wheel too sharply
when machine is in motion.
3. Do not keep the machine in the same position
with pad / brush spinning, keep the machine
moving to prevent damage to oor nish.
4. If the squeegee assembly leaves streaks on the
oor, raise the squeegee o󰀨 the oor and wipe
the blades down with a damp cloth. Pre-sweep
the area to prevent leaving streaks on the oor.
5. To obtain the optimum cleaning performance,
you can adjust the solution ow and detergent
dosage as your required. If poor picking up
water performance is observed, please stop
scrubbing and check the squeegee blade,
adjust or replace if necessary.
6. If the dirty water path exceed the width of
squeegee, please adjust the side squeegee
assembly.
7. Pour a recommended defoamer into the
recovery tank if excessive foam appears.
WARNING: The foam do not activate
water level switch, excessive foam may result
in vacuum motor damage.
8. Press the Horn button (machine components,
#15) to alert if necessary .
9. The machine is equipped with a Warning light
(machine components, #25), remind pedestrians
to avoid the road.
10. If there is a fault code on the LED display
screen, the machine will stop scrubbing and
alarm, troubleshoot (see Troubleshooting)
before using the machine.
11.For very dirty oors, select the switch by
working mode single brush non-suction working
mode is selected.
12. If you only want to pick up water needn't
scrubbing, Turn on the Vacuum motor switch
(squeegee will lower down) and turn o󰀨 the
1-Step switch (if it is ON), the scrub head will
raise and then start to working.
WARNING: While driving, do not make
sharp turn in case of rollover.
- The device is equipped with a turning angle
sensor which will slow down the running speed
if it detects that you are making turn or turning
around.
- Please drive slowly when you are trying to make
turn.
WARNING: Please do not operate the
machine on slope which is exceeding 17% in
case of rollover.
- Please sit straight in case of rollover while
driving.
- Please do not stop or turning around on slope in
case of rollover.
WHILE OPERATING MACHINE