Need help?Do you have a question about the Ice-O-Matic CIM1135A and is the answer not in the manual?
Important warnings and cautions for safe operation and maintenance.
Explains the sequence of operations and LED status during the freeze cycle.
Describes the start of the Harvest Cycle based on the Low Float Switch.
Explains the energizing of valves and relays during the harvest cycle.
Unit shutdown procedure when bin is full, based on curtain switch or bin thermostat.
Unit restarts freeze cycle after harvest, filling sump until high water float opens.
Explains LED flash patterns, error codes, and minimum/maximum times.
Details the LED sequence and component status during the initial freeze cycle.
Details LED sequence and component status during the initial harvest cycle.
Describes LED status and component operations during the transition from harvest to freeze.
Details LED status and shutdown conditions when the bin is full.
Details controller states, component status, and LED indications during freeze diagnostics.
Details controller states, component status, and LED indications during harvest diagnostics.
Steps to diagnose float switch issues, checking LEDs, and continuity.
Steps to diagnose issues with the water pump not running.
Steps to diagnose issues with the water inlet valve not opening.
Steps to diagnose issues with the purge valve not opening.
Explains how the assembly is energized and moves to release ice.
Steps to verify operation and diagnose issues with the assembly.
Steps to diagnose issues if the LED on the board is off when the curtain is closed.
Set to open at 450 psig to de-energize the contactor as a safety.
Maintains head pressure by closing at 250 psig and opening at 200 psig.
Diagnosing issues with high pressure cutout and fan cycle controls.
Steps to diagnose inoperable fan motor or cycling issues.
Identifies issues like rust, improper cleaning, or ice formation problems.
Bi-metal thermostat strapped to hot gas valve line to shut down compressor if temp exceeds 180°F.
Steps to diagnose issues if the compressor doesn't run with R2 LED illuminated.
General advice on using gauges and verifying operating pressures.
Details TXV function and troubleshooting for proper bulb mounting and suction pressure.
Explains operation and troubleshooting for hot gas valve.
Details the function and diagnosis of the mixing valve in low ambient conditions.
Two-part process: descaling and sanitizing, with recommended frequencies.
Eye protection and gloves are recommended when handling chemicals.
Detailed steps for initiating and running the cleaning cycle, including descaler addition.
Wiring diagram for single evaporator units.
Wiring diagram for 220-240V, 50Hz, single phase units.
Wiring diagram for three-phase single evaporator units.
Wiring diagram for single phase dual evaporator units.
General| Brand | Ice-O-Matic |
|---|---|
| Model | CIM1135A |
| Category | Ice Maker |
| Language | English |
To Next Page