OPERATOR
ICE iP17 iP20
Directions for the grinding and crystallization processes
Grinding process
Prepare the following tools and items:grinding disc holder, grinding disc(usually the granularity is
on the stone surface using a window squeegee. Repeat the procedure as required until there
granularity (the smaller the granularity number, the coarser the disc)) and then fit it onto the
machine. Fill the tank with water.
Prepare the following tools and items:pad driver. fiber pad (steel pad), dust mop, K2 stone
treatment, or K3 stoneshining plasm, or crystallization powder.Fit the pad driver onto the
high gloss and enter the next area. If using the crystallization powder, you can mix the powder
with the next larger granularity. Use the above directions,and continue grinding until the result is
acceptable.
Caution, Make sure there is no sand on the floor. The grinding disc should be
installed uniformly. Be sure to grind slowly and evenly with enough water.You
must completely remove the powder from the last process before beginning next
process. Immediately clean the floor with the vacuum cleaner,replace the grinding
disc from coarsely granular to finely granular. You can’t skip steps. There is coarse
grind,half-finishing grind and finishing grind,During finishing grind, if you feel
resistance, you can reduce the quantity of Iron bar.
Crystallization process
Caution: It’s best if there is no wax application on the floor. The floor MUST be free
of water and dirt. The color of the pad is white (or colorless). Replace pad if dirty.
To Next Page
Loading...
Need help?
General
