ICE iP17 iP20
OPERATOR
HANDLE RELEASE ASSEMBLY INSTRUCTIONS
1) Assemble handle and handle release assembly: According to in the following
photos direction assembly.
Step 2
1) Take out the handle assembly, nut lock M12,
hex. socket head M12x210.
Step 1
2) After Aligning them, and use spanner to tighten them.
2) Adjust the nylon lock nut: It don't over tighten nylon lock nut, only tighten it
enough to hold handle in place when compression lever is in down position.
Step 3
1) Connect power cords together
To Next Page
Loading...
